How to Apply Seal Coat

​“Rhynotite” Product Application

1. Clean pavement of all dirt, dust, and debris
2. Fill cracks and patch all broken and alligatored areas with either hot mix or a cold patch material
3. Prime all oil spots with a latex product
4. “Rhynotite” may be applied by a hand or motorized squeegee or spray
5. Apply in any climate except raining or freezing weather with an additional additive, sunshine, wind, low humidity and elevated ambient temperatures will speed curing time
6. Can be diluted with clean, potable water. Mix dilution is a maximum of 20%. DO NOT over dilute the product as this will decrease the overall product performance and even lose viscosity with may cause the aggregate to fall to the bottom of the tank. Additionally, less water used to dilute will increase dry time. Product can be applied not diluting it at all.
7. Product is completely cured when water dries completely from the surface
8. For best results, use of “water-born” paint is recommended when striping seal coated areas.